Stub-Up Bend Calculator
Enter the desired stub height and the take-up value from the bender or field method to estimate the mark measured from the conduit end.
Open calculatorConduit Bending
Saddle, offset, kick, segment, rolling offset, and multiplier workflows for field conduit layout.
Published Calculators
Rolling Offset Calculator
Use this rolling-offset workflow when the conduit must move in both horizontal and vertical directions. It is a geometry aid, not a bender-specific procedure.
Open calculator
Conduit Cut Length Calculator
Add straight conduit runs, bend count, shrink per bend, and optional waste allowance to create a transparent cut-length estimate.
Open calculator
Concentric Bend Calculator
Use this concentric bend workflow to space parallel conduit bends from an inside radius, conduit spacing, bend angle, and segment count.
Open calculator
Box Offset Calculator
Use this focused box-offset workflow when conduit must clear a box or fitting. It keeps the box depth and reference distance visible without assuming a specific bender.
Open calculator
Segment Bend Calculator
Use total bend angle, number of segment bends, desired radius, and a start mark to lay out equal segment bend marks.
Open calculator
Offset Bend Calculator
Use rise height, bend angle, and the first mark distance from the conduit end to estimate the second mark and offset layout geometry.
Open calculator
Parallel Offset Calculator
Use offset rise, bend angle, conduit center spacing, first mark, and conduit count to lay out staggered marks for parallel conduit offsets.
Open calculator
Kick Bend Calculator
Use kick or rise height, bend angle, and the distance from the conduit end to the bend mark to estimate the obstruction edge mark and related layout measurements.
Open calculator
Saddle Bend Calculator
Calculate 3-point saddle bend layout marks from obstruction height, outside bend angle, and center mark location.
Open calculator